>Monday’s Mistake – can you spot the mistake/s in the picture?
>
This is a forward-facing Britax Boulevard installed in the center of a 2006 Honda Pilot (for those who are curious, the top tether is attached properly – it just isn’t shown in the picture).
Stay tuned for some great teaching tips tomorrow on LATCH when I post the answers.
>I haven't seen how the LATCH works on a booster seat yet but I'm pretty sure it's not supposed to go around that bar. Also, I think the manual says to use LATCH OR seat belt but not both.
>This isn't a booster seat. It's a convertible car seat and that is where the LATCH hooks are connected to. Seat is not allowed to be installed with both LATCH and seat belt and I don't believe this vehicle allows a center LATCH install.
>LATCH and seatbelt should not be used at the same time and the seatbelt should go over the LATCH bar for a shoulder belt install. and i can't tell for sure but i wouldnt be surprised if the LATCH was upside down.
>1. Both LATCH and SEATBELT are used2. LATCH is not allowed in the center of most Hondas IIRC (not our Civic, anyway!)
>I also want to comment to check that the Latch Clips are facing the right way. Its hard to tell from this picture if they are upside down or not.